Assembling The Fan - Hunter 42616-01 Installation And Operation Manual

3 • Assembling the Fan
Standard or Angle Mounting
Steps 3-2 – 3-3
Set Screw
6
Low Profile Mounting
Steps 3-5 – 3-6
Green
Ground
Wire
Canopy
Trim Ring
Locking Screw
Hunter Fan Company
42616-01 rev 02-14-06.indd
WARNING: Fan may fall if not assembled as directed in these
installation instructions.
3-1. Unbundle the wires from the fan.
For Standard or Angle mounting:
Downrod
3-2. Insert the downrod through the canopy and canopy trim ring.
Feed the wires from the fan through the downrod on one side of
the pin in the ball.
Canopy 3-3. Loosen the square head set screw on the adapter to install the
pipe and ball assembly. Note: When the pipe and ball assembly
is fully installed, 2-3 threads on the pipe will still be visible; this is
Canopy normal. Securely retighten the set screw with a wrench or pliers.
Trim Ring
not remove this coating; the coating prevents the downrod from
unscrewing. Once assembled, do not remove the downrod.
For Low Profile mounting:
Note: For low profile mounting, the downrod is replaced with the
low profile washer.
3-4. Remove the set screw from the adapter.
Locking Screws
3-5. Place the low profile washer into the canopy with the lip down.
3-6. Align the holes in the washer with the holes in the adapter.
Low Profile
Washer
Assemble securely with three locking screws.
Step 3-6 (Detail)
Canopy
6
CAUTION: e adapter has a special coating on the threads. Do
Adapter
2/20/2006, 3:16 PM
Locking Screws
Low Profile
Washer
42616-01 • 02/20/06