Hunter 42616-01 Installation And Operation Manual page 12

8 • Completing Your Installation With or Without a Light Fixture (Continued)
8-6. Push the plug button from inside the lower switch housing to
remove the plug button and switch housing cap. Note: Save the
plug button and switch housing cap should you choose to remove
the light fixture in the future.
8-7. Feed the two wires from the light fixture through the center hole
in the lower switch housing.
8-8. Screw the lower switch housing onto the threaded pipe from the
light kit until tight.
8-9. Align the holes in the top of the light kit with the two holes in the
lower switch housing. Install two screws, then secure the pipe by
installing a nut and washer from inside the lower switch housing.
WARNING: Improper installation could cause the light fixture
to fall.
8-10. Connect the black wire with a white stripe from the lower switch
housing to the black wire from the light kit. Connect the white
wire from the lower switch housing to the white wire from the
12
light kit.
8-11. Connect the 9 pin plug connector from the lower switch housing
to the 9 pin plug connector from the upper switch housing.
8-12. Install the lower switch housing to the upper switch housing.
8-13. Install glass shades and candelabra bulbs (sold separately).
Housing
Assembly
Screw
Hunter Fan Company
42616-01 rev 02-14-06.indd
Steps 8-10 - 8-12
12
Switch
Housing
Plug Button
Cap
Assembly
Screw
Steps 8-8 - 8-9
42616-01 • 02/20/06
2/20/2006, 3:17 PM
Lower
Switch
Housing
Step 8-6