Assembly - Minelab Safari Instruction Manual

6
Attaching the Lower Shaft to the
Upper Shaft:
1 Release the Upper Shaft camlock by pulling
the lever away from the shaft.
2 Feed the coil cable up through the inside
of the Upper Shaft, ensuring the camlock
side of the shaft is facing the ground.
3 Slide the Upper Shaft over the Lower Shaft,
so the coil cable appears out the top.

assembly

Connecting the Shaft Assembly to the
Handle Assembly:
1 Release the Control Box camlock by pulling
the lever away from the Control Box.
2 Align and push the coil cable connector
into the socket underneath the Control Box,
firmly tightening the retaining ring
to secure.
3 Push the Handle Assembly onto the Upper
Shaft, as far as it will go.
4 Lock the Control Box camlock by pushing
the lever flat onto the Control Box.