Minelab Safari Instruction Manual page 23

There are four factory preset Detect Modes
and four Save Modes available for searching.
Each Detect Mode is customized with the
optimum settings, to allow you to find the
types of objects described by the Detect
Mode name.
The four Detect Modes are:
– Coin – Coin & Jewellery
– Relic – All Metal
In some locations, there may be a specific
pattern to the type of targets found in the
area. For example, an old house or building
site may have areas where a certain junk is
concentrated, or other areas where it is more
likely that coins have been lost. On the beach,
foil and modern coins are more plentiful in
the dry sand, whereas less junk and more
gold jewellery are located in the wet sand.
Due to the different types of targets you may
expect in certain areas, you will often prefer a
different Discrimination Pattern for each area.
With Safari you have the choice to search
in one of the factory preset Discrimination
Patterns, or you can create and save your
own patterns to suit the different areas you
commonly search.
Detect Modes
Start – Up
On initial start-up (or after Factory Preset),
your detector will default to the factory Coin
Detect Mode.
To select a different factory preset Detect
Mode, press and release the appropriate
Mode button.
The icon next to the corresponding preset
Mode
Mode has been selected. The detector will
apply the factory determined Discrimination
Pattern and audio response for that Mode.
Note: You cannot change Detect Modes while in
Pinpoint mode.
, indicates that a factory preset
21