Table of Contents
Advertisement
MENU SELECTIONS
3. VOL (Volume)
Press
to illuminate the VOL menu icon.
The default volume setting is 7.
Press
to increase speaker volume. Maximum volume is at setting 20.
Press
to lower speaker volume. The minimum volume setting is 0, no
sound.
With volume set to 0, the Target-ID, Depth Bar Graph and Iron-Indicator will
function as normal, but the detector will not emit a sound when targets are
detected.
The overload volume signal will always sound off in the event of signal
overload, even with the volume set to 0.
Because the Eurotek Pro is so sensitive to even the smallest iron targets, the
detector incorporates a feature to reduce the volume of iron targets to
minimize user fatigue.
Volume settings 10 - 20 are available to control the volume level of iron
targets.
As you increase volume from 10 to 20, iron-volume changes from silent to
maximum. Note that, depending on the DISC setting, iron targets may
induce V.C.O. tones; in this case, the V.C.O. tones in the iron range (ID 1
- 40) will also have the same reduced volume.
At each of the 10 - 20 volume settings, nonferrous target response is maximum
volume.
Volume control applies only to motion target detection.
Volume changes do not affect the Pinpoint Mode volume, or the
keypad volume.
Setting
Nonferrous
1
2
3
4
5
6
7
8
9
10
Volume Settings are as follows:
Volume
Ferrous
1
1
2
2
3
3
4
4
5
5
6
6
7
7
8
8
9
9
10
0
Setting
Nonferrous
11
10
12
10
13
10
14
10
15
10
16
10
17
10
18
10
19
10
20
10
Volume
Ferrous
1
2
3
4
5
6
7
8
9
10
13
Advertisement
Table of Contents
