MAINTENANCE
CAUTION
Cleaning and maintenance must be carried out when fi lter lamp lights. Before cleaning, stop
operation and switch off the power supply.
1.
PRE-FILTER
Clean the pre-fi lter, as it removes dust inside the room. In case the pre-fi lter is full of dust, the air
fl ow will decrease and the cooling capacity will be reduced. Further, noise may occur. Be sure to
clean the pre-fi lter following the procedure below.
1
Open the front panel and remove the pre-fi lter
Gently lift and remove the air purifying fi lter
●
from the pre-fi lter frame.
2
Vacuum dust from the pre-fi lter and air purifying
fi lter using vacuum cleaner. If there is too much
dust, rinse pre-fi lter under running tap water
and gently brush it with soft bristle brush. Allow
fi lters to dry in shade.
3
Re-insert the air purifying fi lter to the fi lter
●
frame. Set the pre-fi lter with "FRONT" mark
facing front, and slot them into the original
state.
After attaching the pre-fi lters, push the front
●
panel at three arrow portions as shown in
fi gure and close it.
NOTE:
Air purifying fi lter should be cleaned every month or sooner if noticeable loading occurs. When
●
used overtime, it may loose its deodorizing function. For maximum performance, it is recommended
to replace it every 1 year depending on application requirements.
CAUTION
Do not wash with hot water at more than 40°C. The Pre-fi lter may shrink.
●
When washing it, shake off moisture completely and dry it in the shade; do not expose it directly
●
to the sun. The Pre-fi lter may shrink.
Do not use detergent on the Pre-fi lter as some detergent may deteriorate the Pre-fi lter electrostatic
●
performance.
●
Do not operate the air conditioner without Pre-fi lter. Dust may enter the air conditioner and fault
may occur.
EN3 RAS-RAC-S18CDT 18
EN3 RAS-RAC-S18CDT 18
– 18 –
1/6/14 4:55 PM
1/6/14 4:55 PM