Operating Procedures & Maintenance; Unpacking Your Ice Maker; Connecting Your Ice Maker - SPT IM-101 Instruction Manual

OPERATING PROCEDURES

UNPACKING YOUR ICE MAKER

1. Remove all exterior and interior packaging materials. Check that the ice basket and ice scoop
is included. If any parts are missing, please contact our customer service.
2. Clean the interior with lukewarm water and a soft cloth or clean the unit using the Self-Clean
function (see page 7). Take out the ice basket before cleaning.
3. Find a location for your ice maker where it's protected from direct sunlight and other sources
of heat (i.e. stove, furnace, radiator). Place the ice maker on a level surface. Make sure that
there is at least 5 inches of space between the back and sides of your ice maker and the wall.
4. Allow one hour for the refrigerant to settle before plugging the unit for initial use.
5. The appliance must be positioned so that the plug is accessible.

CONNECTING YOUR ICE MAKER

1. This unit should be properly grounded for your safety. The power cord is equipped with a
three-prong plug which mates with standard three prong wall outlets to minimize the
possibility of electric shock.
2. Plug your appliance into a dedicated, properly installed and grounded wall outlet. Do not
under any circumstances, cut or remove the third (ground) prong from the power cord. Any
questions concerning power and/or grounding should be directed toward a certified
electrician.
3. This appliance requires a standard 110-120volt, 60Hz electrical outlet with three-prong
ground.
IMPROPER USE OF THE GROUNDED PLUG CAN RESULT IN RISK OF ELECTRICAL
SHOCK. IF THE POWER CORD IS DAMAGED, PLEASE CONTACT CUSTOMER SERVICE.
DANGER
6