Remote Control Code; Advanced Operations; Reference - Panasonic SC-HTB20 Operating Instructions Manual

Advanced operations

Changing the dual audio
Change the dual audio from main to secondary.
1 Confirm the digital audio output setting on the
connected TV or player, etc. is set to "Bitstream".
2 Press and hold [TV] for more than 2 sec.
3 While the indicator of the current setting is blinking,
press [TV] to change the setting.
A : Main
B : Secondary
A, B : Main and secondary
≥ The setting works only when the dual audio is
available in the audio source.
≥ The setting is maintained until it is changed again.
≥ The same setting is used for [TV] and [BD/DVD] audio
sources.
Auto gain control
This function adjusts the volume automatically when the
volume exceeds a certain level. With this function, you
can prevent sudden loud sounds.
1 Press and hold [AUX] on remote control for more than
2 sec.
≥ The indicator for the current setting blinks for 10 sec.
Dolby Digital indicator blinks:
Auto gain control is on.
PCM indicator blinks:
Auto gain control is off.
2 While the indicator is blinking, press [AUX] to
change the setting.
≥ The setting changes each time [AUX] is pressed.
≥ The setting is maintained until it is changed again.
≥ Default setting of this function is OFF.
To turn off the 3D
surround effect and
clear-mode dialog effect
Depending on your preference, it is possible to use only
the Dolby Virtual Speaker effect by turning off the 3D
surround effect and the clear-mode dialog effect.
1 Press and hold [BD/DVD] on remote controller for
more than 2 sec.
≥ The indicator for the current setting blinks for 10 sec.
Dolby Digital indicator blinks:
3D surround effect and
clear-mode dialog effect are on.
PCM indicator blinks:
3D surround effect and
clear-mode dialog effect are off.
2 While the indicator is blinking, press [BD/DVD] to
change the setting.
≥ The setting changes each time [BD/DVD] is pressed.
≥ The setting will be reset to on when this system is
turned off.
Auto standby function
With this function turned on, this unit can be set to
automatically switch to standby mode if there is no signal
input and no operation is performed for 2 hours.
1 Press and hold [INPUT SELECTOR] for more than 2
sec.
≥ The indicator for the current setting blinks for 10 sec.
Dolby Digital indicator blinks:
Auto standby function is on.
PCM indicator blinks:
Auto standby function is off.
2 While the indicator is blinking, press [INPUT
SELECTOR] to change the setting.
≥ The setting changes each time [INPUT SELECTOR]
is pressed.
≥ The setting is maintained until it is changed again.
Others
The following settings are unnecessary under
general usage conditions of the system.

∫ Remote control code

When other Panasonic devices respond to this system's
remote control, change the remote control code on the
active subwoofer and the remote control.
(Continued on the next page)
25
VQT4E52