Audio Output Modes - Panasonic SC-HTB20 Operating Instructions Manual

Audio output modes

As a factory preset, Dolby Virtual Speaker and
the 3D surround effects will be applied to Multi-
channel audio sources, such as those from a Blu-
ray Disc player or DVD player, etc.
By changing the audio output setting, it is
possible to apply the Dolby Virtual Speaker and
3D surround effects to 2ch audio sources, such
as the audio from the TV.
To change the audio
output mode
Press and hold [MUTE] for more
than 2 sec.
≥ The indicator for the current setting blinks for 10 sec.
While the indicator is blinking,
press [MUTE] again to change
the setting.
≥ The setting changes each time [MUTE] is pressed.
Audio output mode
Multi-channel mode
Auto mode (Direct mode)
(Factory preset)
 2
2ch mode
§1 Depending on the audio source, Dolby Virtual Speaker
and 3D surround effect settings are automatically
adjusted.
When using the optical digital audio cable, Dolby Virtual
Speaker and the 3D surround effect will be automatically
cancelled if the audio signal's sampling frequency is greater
than 48 kHz.
Dolby Virtual
Speaker and 3D
surround effect
The effects are
applied to all audio
sources.
The effects are
§1
applied to Multi-
channel audio
sources.
The effects are not
applied to 2 channel
audio sources.
§2 This indicator will
also blink when
the audio source
is Multi-channel
audio.
The effects are not
applied to any
audio source.
23
VQT4E52