Advanced Operations; Reference; Remote Control Code - Panasonic SC-HTB20 Owner's Manual

Advanced operations

Changing the dual audio
Change the dual audio from main to secondary.
1 Confirm the digital audio output setting on the
connected TV or player, etc. is set to "Bitstream".
2 Press and hold [TV] for more than 2 sec.
3 While the indicator of the current setting is blinking,
press [TV] to change the setting.
A : Main
B : Secondary (SAP: Secondary Audio
Program)
A, B : Main and secondary
≥ The setting works only when the dual audio is available
in the audio source.
≥ The setting is maintained until it is changed again.
≥ The same setting is used for [TV] and [BD/DVD] audio
sources.
Auto gain control
This function adjusts the volume automatically when the
volume exceeds a certain level. With this function, you can
prevent sudden loud sounds.
1 Press and hold [AUX] on remote control for more than
2 sec.
≥ The indicator for the current setting blinks for 10 sec.
Dolby Digital indicator blinks:
Auto gain control is on.
PCM indicator blinks:
Auto gain control is off.
2 While the indicator is blinking, press [AUX] to change
the setting.
≥ The setting changes each time [AUX] is pressed.
≥ The setting is maintained until it is changed again.
≥ Default setting of this function is OFF.
To turn off the 3D surround effect
and clear-mode dialog effect
Depending on your preference, it is possible to use only
the Dolby Virtual Speaker effect by turning off the 3D
surround effect and the clear-mode dialog effect.
1 Press and hold [BD/DVD] on remote controller for
more than 2 sec.
≥ The indicator for the current setting blinks for 10 sec.
Dolby Digital indicator blinks:
3D surround effect and
clear-mode dialog effect are on.
PCM indicator blinks:
3D surround effect and
clear-mode dialog effect are off.
2 While the indicator is blinking, press [BD/DVD] to
change the setting.
≥ The setting changes each time [BD/DVD] is pressed.
≥ The setting will be reset to on when this system is turned off.
≥ When off is selected, the dialog effect level cannot be adjusted.
Others
The following settings are unnecessary under
general usage conditions of the system.

∫ Remote control code

When other Panasonic devices respond to this system's
remote control, change the remote control code on the
active subwoofer and the remote control.
Preparation
≥ Turn off all other Panasonic products.
≥ Turn on this system.
Change the remote control code to code 2:
1 Aim the remote control at this system's remote control
sensor.
2 Press and hold [MUTE] and [BD/DVD] on the remote
control for more than 4 sec.
≥ All the indicators will blink for 10 sec when the code of
this system is changed.
≥ The setting is maintained until it is changed again.
≥ If this system does not operate after changing the code,
repeat steps 1 and 2.
≥ To change the remote control code to code 1, repeat the
steps above, but replace [BD/DVD] with [TV].
(Continued on the next page)
25
VQT4D53