Toshiba Strata DK User Manual page 19

2. Lift the handset and

press
3. Hang up.
To cancel Call Forward-External
Lift the handset and press
Remote Call Forward—External Destination Change
If Call Forward-External mode is set at your station, you can change the forwarding
destination from a telephone outside of the system.
The destination is normally an external Public Telephone Network Number, but it can also
be an internal Directory Number.
To change the destination number
1. Call into the Strata
DK system over a CO
line programmed for
the DISA feature.
2. After you hear dial
tone, press
then enter a [PDN].
Strata DK Standard Telephone 5/00
Example: 8015833700
801 = CO Line access code
5833700 = Telephone number
Important!
Group access codes. The LCR access code "9" cannot be
used.
.
Incoming calls will forward to the destination stored at
Station Speed Dial Location 49.

You hear ring back tone signal, then internal dial tone for
10 seconds. Try again if you hear busy tone.
See the System Administrator for DISA telephone
Note
numbers.
You hear a confirmation tone.

,
If a number is not dialed, the system automatically causes
the DISA CO line to ring at telephones as a normal
incoming call. Then, if the call is not answered within 15
seconds after the ringing starts, it disconnects.
See Table 1 on Page 38
.
Features
Call Forward
for CO Line/Line
11