Stand - Delta 28-195 Instruction Manual

ASSEMBLY INSTRUCTIONS
WARNING: FOR YOUR OWN SAFETY, DO NOT CONNECT THE MACHINE TO THE POWER SOURCE UNTIL
THE MACHINE IS COMPLETELY ASSEMBLED AND YOU READ AND UNDERSTAND THE ENTIRE OWNER'S
MANUAL.
ASSEMBLING
A
B
STAND AND FEET
1. Assemble the stand, as shown in Fig. 4, using the
E
32 M8x20mm Carriage head screws, 3/8" flat washers
and M8 hex nuts supplied. The two 10-3/4 long upper
braces (A); 13-9/16 long upper braces (B); 15-3/4 long
lower braces (C); and 18-5/16 long lower braces (D)
should be fastened to the four legs (E). Insert the
carriage bolts through the legs and braces, place flat
D
C
washer on carriage bolt and secure with nut.
IMPORTANT: The top lips of the two upper braces (A)
should be on top of the top lips of upper braces (B).
F
2. Assemble the four feet (F) Fig. 4, to bottom of each
Fig. 4
leg (E), as shown.
A
A
B
C
Fig. 5
ASSEMBLING
BAND SAW TO STAND
1. Place the band saw on top of the stand and line up
the four holes, located on the feet of the band saw, with
the four holes located on top of the stand.
2. Fasten the band saw to the stand using the four M8
x 35mm hex head bolts (A) Fig. 5, eight M8 flat washers
(B) and four M8 hex nuts (C), supplied. Place an M8 flat
washer on the hex head bolt and insert bolt through hole
on the band saw feet and hole in the stand. Place a flat
washer on the hex head bolt that has been inserted
through the saw and stand and secure with M8 hex nut.
3. Figure 6 illustrates the band saw assembled to the

stand.

Fig. 6
8