Drill Master 750X User Manual page 15

Reversing or Replacing Your Diamond
Sharpening Wheel
1.
Wheel Access Cover
2.
Drill Doctor seen from below.
3.
Drill Doctor seen from below.
26
Unplug your Drill
Doctor, make sure
machine is cool, then
remove wheel cover.
Turn the Quick
Change Knob clock-
wise while holding
the Sharpening Wheel
to keep it from turn-
ing.
Remove the wheel,
replace, and tighten
the Quick Change
Knob by turning
c o u n t e r- c l o c k w i s e
while holding the
wheel to keep it from
spinning.
www.drilldoctor.com
Accessories
Order accessories
www.DrillDoctor.com, or by contacting us at the phone
number listed on the Warranty page (page 28), or at the
retailer where you purchased your Drill Doctor.
3/32" to 3/4" Large Bit Chuck
Part # DA70100PF
3/32" to 1/2" Left-handed Bit Chuck
(for 3/32"-1/2" reverse twist drill bits)
Part # DA02105PF
Standard Diamond Sharpening Wheel
(180 grit)
Part # DA31320GF
Coarse Diamond Sharpening Wheel
(100 grit)
Part # DA31325GF
WARNING:
The use of any accessory other than one rec-
ommended in this user's manual may present
a risk of personal injury.
www.drilldoctor.com
through our website:
27