Health in motion Inspire FT2 Assembly & Operation Manual page 23

2 – M6*12 Button Head Bolts (95)
2 – M6 Flat Washers (101)
59
2 – M8*16 Button Head Bolts (84)
2 – M8 Flat Washers (100)
A) Attach a Front Upper Shroud Mount Bracket (59) (with the horizontal rib facing
towards outside of the machine) to the top back of the Right and Left Front
Upright (4R & 4L) using 2- M6x12 Button Head bolts (95) and 2- M6 washers (101)
on each as shown. Tighten these bolts now.
B) Attach the Left and Right Upper Shroud Mount Brackets (60 & 61) to the Left and
Right Top Beams (16 & 15) using 2-M8x16 Button Head Bolts (84) and 2-M8 washers
(100) on each as shown. Leave loose. These will be tightened in Step 15.
C) Attach an Accessory Hanger Bracket (49) to the bottom/back of both the Left and
Right Top Beams (16 & 15) using 2- M6x12 Button Head bolts (95) and 2- M6
washers (101) on each as shown. Tighten these bolts now.
STEP 14 Shroud Mount Brackets
Front Upper Shroud Mount Bracket (59
facing to the outside of the machine.
Left
Bracket
(60)
16
49
2 – M6*12 Button Head Bolts (95)
2 – M6 Flat Washers (101)
PAGE 20
Make sure the horizontal rib is
)
15
49
Right
Bracket
(61)