Health in motion Inspire FT2 Assembly & Operation Manual page 17

1 – M10*120 Hex Bolt (78)
2 – M10 Flat Washers (97)
1 – M10 Locknuts (98)
1
2 – M10*115 Hex Bolt (92)
4 – M10 Flat Washers (97)
2 – M10 Locknuts (98)
Note: Make sure guide rod bolts insert from inside of machine to outside.
A) Attach 2 Guide Rods (24) to the Right Main Base (1) using 2- M10x115 Hex bolts (92), 4-
M10 Washers (97) and 2- M10 Lock nuts (98). Tighten these bolts now.
B) Slide the Weight Stack Risers (26), Rubber Donuts (75) and 15 Weight Plates (25) onto the
Guide Rods (24). Make sure the weight sticker cut out is facing the inside of the machine.
Note: For the optional 215# heavy stack, Do Not put on the Weight Stack Risers
(26) and put on 20 Weight Plates (25).
C) Screw the Top Weight Pulley Bracket Assembly (27) onto the Selector Stem in the Top
Weight (23). Thread all the way down but do not tighten yet. Make sure the Add On
Weight (58) slides onto the Top Weight easily, if not unscrew the Pulley Bracket
until it fits. Slide the Top Weight assembly (23) onto the Guide Rods (24) so the 4-
1/2"Pulley is positioned between the Guide Rods (24) as shown in detail above.
D) Insert a Weight Pin (28) into the stack.
STEP 9
15
65
24
PAGE 14
Weight Stacks
2 – M10*85 Hex Bolt (89)
4 – M10 Flat Washers (97)
2 – M10 Locknuts (98)
27
23
25
28
75
26