Health in motion Inspire FT2 Assembly & Operation Manual page 18

E) Attach the 2 Guide Rods (24) to the Right Top Beam (15) using 2- M10x85 Hex bolts (89), 4-
M10 Washers (97) and 2- M10 Lock nuts (98), inserted first through the Guide Rods, from
inside to outside. Tighten these bolts now.
F) Attach a 3-1/2" Pulley (65) to the spacer welded to the Right Top Beam (15) behind the
Guide Rods (24), using 1- M10x120 Hex bolt (78), 2- M10 Washers (97) and 1- M10 Lock nut
(98). Tighten this bolt now.
G) Stick a weight stack sticker (1-16 or 1-21 for heavy stacks) on the Top Weight and the
sticker cut out on each weight plate.
H) Lubricate the Guide Rods (24) with Super Lube or the Lube provided.
Repeat Step 9 on the left side of the machine for the second Weight Stack as shown
below.
25
28
75
STEP 9 continued
27
23
26
16
65
24
PAGE 15
1 – M10*120 Hex Bolt (78)
2 – M10 Flat Washers (97)
1 – M10 Locknuts (98)
2 – M10*85 Hex Bolt (89)
4 – M10 Flat Washers (97)
2 – M10 Locknuts (98)
2
2 – M10*115 Hex Bolt (92)
4 – M10 Flat Washers (97)
2 – M10 Locknuts (98)