Health in motion Inspire FT2 Assembly & Operation Manual page 22

Plastic Bushing
(slotted)
Rear Guide Cable
(shorter)
A) Thread one end of the Side Guide Cable (35) into the threaded insert in the side/bottom of
the Right Top Beam (15) just above the side floating pulleys (22) for 5 full turns.
B) Thread the other end of the Side Guide Cable (35) into the threaded insert in the Right Main
Base (2) next to the pulley. Thread in until this cable is taught. Tighten the Jam nuts on
both ends to the threaded inserts now.
C) Repeat for the left side now.
D) Thread one end of the Rear Guide Cable (36) into the threaded insert in the rear/bottom of
the Right Top Beam (15) just above the rear floating pulleys (22) for 5 full turns.
E) Thread the other end of the Rear Guide Cable (36) into the threaded insert in the top of the
Rear Cross Base (3) behind the large pulley. Thread in until this cable is taught. Tighten
the Jam nuts on both ends to the threaded inserts now.
F) Repeat for the left side now.
G) Slide the slot of a plastic bushing around each of the 4 Guide Cables (35 & 36) above the
floating pulleys (22) and insert the bushings into the hole of the tabs sticking out from the
floating pulley brackets until they snap in place. The plastic bushings should be between the
cables and the metal tabs on all 4 Guide Cables.
STEP 13
22
36
PAGE 19
Guide Cables
15
3
2
35
Side Guide
Cable (longer)