Weight Bar ( - Health in motion Inspire FT2 Assembly & Operation Manual

12
11
10
A) Place the Right and Left Sliders (8&9) (from step 4) at the same number position
on each Front Upright (4R & 4L).
B) Slide a Shock Absorbing Spring (11) over each Linear Bearing Shaft (10) and rest on the
Slider (8&9) as shown.
C) Place the Right and Left Linear Bearing Sliders (12&13) on the Weight Bar (7) as shown.
Carefully lower the Weight Bar (7) down onto the Linear Bearing Shafts (10) being careful
to not damage the Linear Bearings inside the Sliders (12&13). Continue lowering the
Weight Bar (7) down being careful to keep the bar level or it will bind and damage the
Linear Bearings. Rest the Weight Bar (7) with Linear Bearing Sliders (12&13) on the
Springs (11) on top of each Slider (8&9).
STEP 5
7
13
11
4R
10
8
PAGE 10
Weight Bar
4L
9