GNS 1800 Series User Manual page 73

3. Setup Functions
3.10 Motion Tracking Setup
8. Range Screen Value - Inputs the left or right value for the currant camera position.
9. Range Enable - If selected the camera will only move within the set pan values.
10. Tilt - Assign the minimum angle for the Tilt based on the 'Start Position'.
11. Tilt Screen Value - Inputs the Tilt value for the currant camera position.
12. Tilt Enable - If selected the camera will only move within the set tilt values.On/Off Time - Select the time
for the motion Tracking function to be activated. The default value is 00:00~24:00 (continoue for 24 hours).
13. Disable PTZ Mode - Disables the PTZ mode while the Motion Tracking Function is activated.
14. Currant Image - Displays the currant image from the PTZ camera. The camera can be moved by clicking
on the camera image.
15. Pan Angle - Adjust the Pan angle when the selection box is out of the postition from the left and right
values selected.
16. Tilt Angle - Adjust the Tilt angle when the selection box is higher or lower than the position that was
clicked.
17. Sensitivity - Adjust the sensitivity of the motion tracking function. In dark areas the senstitivity should be
adjusted higher and lower in bright areas.
18. Camera flip - If the camera is installed upside down, the pan, tilt functions will work in reverse. Select this
function to correct that problem.
19. On/Off Time - Select the time from which the motion tracking function will be activated. Select the 'All'
funtion for the motion tracking function to be activated at all times.
Tip - The speed dome camera will track the most active movement among many moving objects. When the
motion tracking is set to a Pan/Tilt camera, 'Motion Tracking' will be displayed on the camera screen.
The DVR system will lose the configured position value when you use the Zoom/Focus functions on the motion
tracking enabled camera (It is recommended that the PTZ mode the for motion tracking camera to be disabled).
73