GNS 1800 Series User Manual page 58

3. Setup Functions
3.5 Modem Setup
Emergency Setup
1. Motion for Emergency - Select the desired cameras to send an emergency message when motion is
activated.
2. Sensor for Emergency - Select the desired sensors to send an emergency message when activated.
3. Emergency Phone Number - When the DVR system is set up with a PTSN (modem) connection and
connect to a Polaris Center PC, assign up to 2 phone numbers for an emergency connection. When the first
trial fails to connect, it tries to connect to the second number. If the DVR is activated for emergency the DVR
will send an emergency message to the Emergency Monitor program on the Polaris Center PC.
4. Transfer Time - When connection has been made, assign the time in seconds to transfer the image to the
Polaris Center PC. (If any other signal is detected during the transfer, the DVR will transmit the image again.)
5. Emergency IP Address - When the DVR system is set up with a LAN or Leased Circuit connection and
connect to a Polaris Center PC, assign an IP address for an emergency connection. If the DVR is activated for
emergency the DVR will send an emergency message to the Emergency Monitor program on the Polaris
Center PC.
58
1
2
3
5
4