Table of Contents
Advertisement
3. Setup Functions
3.1 Hardware Setup
1
11
Camera Setup
1. Setup - Checkmark the camera to enable the camera.
2. Name – Assign the camera name or title, which will be displayed on the main screen (EX. Front Door, Aisle
1). Up to 14 characters can be used.
3. Sensor – The DVR system can have up to 8 sensors (motion detectors, door contacts, etc.) connected to
it (refer to page 81 to connect sensors to the DVR). Once sensors are connected to the DVR system they can
be assigned to cameras. When the sensor is activated the designated camera will record. Type in the sensor
number (if more than one sensor per camera separate them by commas EX. 1,3,6) to be assigned for the
camera.
4. Motion – Cameras can be activated by motion in other cameras. Type in the camera number (if more than
one camera, separate them by commas Ex. 1,3,6) to be assigned for the camera. Example: If camera 1 has
'2,6' typed in the Motion input, any time cameras 2 or 6 are activated by motion, camera 1 will also record.
Tip - Only cameras that are on motion detection mode can be used in the 'motion' function.
5. P/T – Activates the camera for Pan/Tilt function.
6. Type – Select the PTZ camera type (only available if P/T is checked).
50
2
3
4
12
13
5
6
7
14
15
19
9
8
10
16
17
18
20
Advertisement
Table of Contents
