Setup Configuration - GNS 1800 Series User Manual

3. Polaris Center Setup

3.3 Setup Configuration

1
3
1. Modem connection time – The Polaris Center program disconnects the connections after the select time
(in seconds) if there no response from the DVR site.
2. Display the control status bar – If checked, the Polaris Center program will display the manual control
buttons on the main surveillance screen (as shown below).
3. Watermark – Displays the watermark stamp on the achieved image. Watermark is used to authenticate
the image.
4. Received data save setup
•
Now screen data save – Once the Polaris Center program is connected to a DVR site and is
transmitting video, enabling this function will simultaneously store the images that are transmitted to
the designated hard drive.
•
Remote search data save – Once the Polaris Center program is connected to a DVR site and video
is being transmitted from the search screen, enabling this function will simultaneously store the
images that are transmitted to the designated hard drive.
•
Select save drive – Select the drive that will store the transmitted data if the received data function is
enabled.
5. Use automated reconnection – Once the Polaris Center program is connected to a DVR site and is
transmitting video, this function is to reconnect to the DVR site if connection is lost or interrupted.
6. Number of retry – Input the number of attempts the Polaris Center program will make to connect to the
DVR site if the connection is lost.
7. OK – Saves the changed settings and closes the Setup window.
8. Cancel – Cancels any changes and closes the Setup window.
2
4
7
5
6
8
111