About Zboost® From Wi-Ex; Industry Canada Regulations - zBoost zForce YX240 User Manual

zBOOST® zFORCE YX240 USER GUIDE zBOOST® zFORCE YX240 USER GUIDE
About zBoost® from Wi-Ex®
Wi-Ex® is the leader in cell phone signal boosters. zBoost® enhances the performance of your cell
phone, PDA and wireless data card.
Compatibility – Dual Band zBoosts are compatible with 800MHz and 1900MHz regardless of
technology- including CDMA and GSM.
1-year manufacturer warranty – register your product at www.Wi-Ex.com.
zBoost® products have more awards, more sales and more locations than all other signal boosters
...COMBINED.
FCC Information
FCC ID: SO4YX240-PCS-CEL
Warning: Changes or modifications to this device not expressly approved by Wi-Ex could void the user's
authority to operate the equipment. Note: This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation. This equipment
generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If the equipment does cause harmful interference
to radio or television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna
• Increase the separation between the equipment and receiver
• Connect the equipment to an outlet on a circuit different from that to which the receiver is connected
• Consult the dealer or an experienced radio/TV technician for help
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.
This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
In accordance with FCC requirements of human exposure to radio frequency fields, the radiating element
(antenna) shall be installed such that a minimum separation distance of 20cm (8in) is maintained from all
persons.

Industry Canada Regulations

Canada IC: 5544A-YX240PCSCEL
This Class B digital apparatus meets all requirements of the Canadian Interference Causing Equipment
Regulations. Operation is subject to the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received, including interference that may cause
undesired operation.
The term "IC:" before the radio certification number only signifies that Industry Canada technical
specifications were met.
RF Exposure:
The manufacturer's rated output power of this equipment is for single carrier operation. For situations when
multiple carrier signals are present, the rating would have to be reduced by 3.5 dB, especially where the
output is re-radiated and can cause interference to adjacent band users. This power reduction is to be by
means of input power or gain reduction and not by an attenuator at the output of the device.
Please note: This unit has been approved for use in Canada under RSS 131, however, consent for the use of
this device to improve cellular or PCS coverage, must be obtained through your cellular or PCS provider,
prior to placing the unit in operation. Please refer to the Industry Canada document CPC 2-1-05, Section
i