Traeger COM200 Owner's Manual page 4

CONGRATULATIONS on your purchase of the Traeger COM200.
With proper set-up, operation and maintenance, your Traeger grill unit will
provide years of service.
READ THESE INSTRUCTIONS CAREFULLY BEFORE ATTEMPTING TO
ASSEMBLE THIS UNIT.
SET-UP:
Your Traeger COM200 comes partially assembled. You will need to complete the
assembly by:
1. Uncrating the unit
2. Removing the grease drain pan (14)
3. Installing the axle (28) (see axle and fender components page)
4. Installing the trailer hitch assembly (25)
5. Installing the fenders (22)
6. Plugging in the taillights (33)
7. Installing the grease bucket
8. Attaching the wheels (30)
9. Installing the grills and baffle plate
10. Attaching the hotel pan holder
NOTE: THE ASSEMBLY OF THE COM200 IS A TWO PERSON OPERATION!
STEP 1 - UNCRATING THE UNIT:
Remove all of the staples from around the bottom of the cardboard box that holds
it to the pallet. A claw hammer and pair of vise grips works well for this task.
With two people, one on each side of the box, grab hold of the bottom of the box
and lift it up and over the top of the unit.
The axle is secured to the shipping pallet with bolts . Remove the two bolts and
move the axle to an area where you will not trip over it. Do the same thing with
the trailer tongue.
Roll open the front door of the COM200 and remove everything that is inside the
unit. Pull-out and set aside the porcelain grills and the Drip pan and move them
to a safe place where you will not accidentally step on them.
Tools Required For The Assembly Process:
(2) 3/4" open end wrenches or a 3/4" ratchet set
(1) 7/16" nut driver or 7/16" ratchet set
(1) Tire iron or lug bolt wrench
(1) Claw hammer
(1) Vice grips
(1) Phillips screwdriver or screw-gun