Related Manuals for Traeger COM190
Summary of Contents for Traeger COM190
- Page 1 OWNER’S MANUAL COM190 COMMERCIAL PELLET GRILL FOR OUTDOOR USE ONLY! WARNING! DO NOT STORE OR USE COMBUSTIBLE MATERIALS NEAR THIS APPLIANCE! USE ONLY TRAEGER BRAND HARDWOOD BBQ PELLETS IN THE OPERATION OF THIS UNIT.
-
Page 3: Component Diagram
COMPONENT DIAGRAM 1... - Page 4 COMPONENT DIAGRAM 2...
- Page 5 COMPONENT DIAGRAM 3...
-
Page 6: Tools Required For Assembly
INTRODUCTION Congratulations on the purchase of your Traeger Wood Pellet Grill, Model COM190. With proper set-up, operation, and maintenance, this grill will provide you with delicious food and years of cooking enjoyment. READ THESE INSTRUCTIONS CAREFULLY BEFORE ATTEMPTING TO ASSEMBLE THIS UNIT. SPEND A FEW MINUTES FAMILIARIZING YOURSELF WITH THE PARTS AND DIAGRAMS. -
Page 7: Section One: Assembly Instructions
SECTION ONE: ASSEMBLY INSTRUCTIONS REMOVING THE SHIPPING SUPPORT: As indicated on the diagram below, block up or otherwise support the Grill before removing the Shipping Support in preparation for installing the Trailer Tongue Assembly (71). Remove the two Lag Bolts securing the Shipping Support to the Pallet with your 7/16”... -
Page 8: Important Notice
Remove any temporary blocking used to support the Grill so that it rests on the Wheels (125). Put a board under each wheel as a ramp and carefully roll the COM190 off the end of the pallet. Use the Trailer Tongue Assembly (71) to steer the Grill. Put the Jack Stand down to help you move the Grill. -
Page 9: Section Two: Traeger Support
SECTION TWO: TRAEGER SUPPORT Parts are identified in the front of this manual on the COM190 COMPONENT DIAGRAM, documents. To order parts: Call, E-mail or write to your Traeger Dealer or Traeger Pellet Grills. Please provide your name, phone number, address, Model and Serial Number of the Grill (located on a label inside the Hopper Lid), along with the part identification.
Need help?
Do you have a question about the COM190 and is the answer not in the manual?
Questions and answers