MK Diamond Products MK-660 Owner's Manual page 23

MK-660 tile saw
45° MiteR CUttiNG
NOte: To cut 45º Miters, the 45º Bullnose Miter Guide (MK Diamond Part No. 153201-MK) should be
used.
CaUtiON DO NOt FORCe tHe tOOl. It will do the job better and safer at the rate for
which it was designed.
(A)
Remove the adjustable Cut-
ting Guide
(D)
Position the tile on the 45°
Bullnose Miter Guide and the
Ruler/Stop
(G)
Perform the cut
(B)
Place the 45° Bullnose Miter
Guide on the Ruler/Stop
(E)
Turn the motor ON
(H)
Turn the motor OFF when
work is complete
23
OPeRatiON
(C)
Position the 45° Bullnose Miter
Guide and tighten the retaining
thumbscrew
(F)
Verify cooling flow on both sides
of the blade (See Maintenance
Section to adjust flow)