Safety Label Locations - MK Diamond Products MK-660 Owner's Manual

MK-660 tile saw

saFetY laBel lOCatiONs

The warning labels contain important safety information. Please read the information contained on
each safety label. These labels are considered a permanent part of your saw. If a label comes off or
becomes hard to read, contact MK Diamond or your dealer for a replacement.
Label A
!
For Your Own Safety Read Instruction Manual
Before Operating Saw.
Wear Eye Protection.
Disconnect Saw Before Servicing, when Changing
Cutting Wheels and Cleaning.
Use Tool Only with Smooth Edge Cutting Wheels
Free of Openings and Grooves.
Replace Damaged Cutting Wheel Before Operating.
Do Not Fill Water Bath Above Water Fill Line.
See Manual for Pump Replacement.
NOTICE
!
Most Motor Problems are caused by improper
voltage and extension cords. Cord should be
one-piece and short as possible. Cord
selection should match the following table.
1-2 H.P.
115v 230v
Max. Cord Length
25' 100'
50' 150' Max. Cord Length
75' 250' Max. Cord Length
Label C
Decal/label
A
B
C
D
E
F
WARNING
Label A
FOR INFORMATION ON
SERVICE OR
WARRANTY
No. 12 Wire
PLEASE CALL
No. 10 Wire
1-800-474-5594
No. 8 Wire
Label D
Tile Master Label Sheet Part#166012
location
Cutting Head Front
Cutting Head Front
Cutting Head Back
Cutting Head Back
Cutting Head Back
Cutting Head Back
Label B
Label C
WARNING
!
Grinding/cutting/drilling of masonry, concrete, metal and other materials with silica in
their composition may give off dust or mists containing crystalline silica. Silica is a basic
component of sand, quartz, brick clay, granite and numerous other minerals and rocks.
Repeated and/or substantial inhalation of airborne crystalline silica can cause serious
or fatal respiratory diseases, including silicosis. In addition,California and some other
authorities have listed respirable crystalline silica as a substance known to cause cancer.
Label B
CAUTION
!
This saw is to be used
with a Ground Fault
Circuit Interrupter.
Label E
Description
Warning - Read Owner's Manual
Warning - Silica Warning
Notice - Voltage / extension cords
Service / Warranty
Caution - Use with GFCI only
Caution - Receptacle for water pump
11
Label D Label E Label F
CAUTION
!
Receptacle is for
water pump only.
125V, .6 amps max.
Label F
saFetY