Cutting Head Installation; Diamond Blade Installation - MK Diamond Products MK-660 Owner's Manual

MK-660 tile saw

CUttiNG HeaD iNstallatiON

Follow the assembly instructions to prepare your MK-660 Saw for operation.
NOte: If the Cutting Head is installed, go to step next step.
(A)
Place the Flat Washer onto
the Height Adjusting Knob
(D)
Install the Adjusting Knob

DiaMOND BlaDe iNstallatiON

When installing the Retaining Screw, do not "cross-thread" and DO NOT over tighten the
NOte:
screw.
(A)
Loosen the Blade Guard
Retaining Screw
(B)
Align Cutting Head Pivot
Hole to the Post, Pivot Shaft
(B)
Open the Outer Blade Guard to
expose the Retaining Nut and
Flanges
15
asseMBlY
(C)
Verify the Cutting Head is
completely installed and seated
on the Pivot Shaft
(C)
Using the Blade Nut Wrench,
loosen and then remove the
Retaining Nut and Outer Flange