Removing And Installing The Battery Tray Shroud; Removing And Installing The Controller Module - Golden compass Service Manual

G. Removing and Installing the Battery Tray
Shroud
CAUTION: When working in this area of the
power chair, use a cloth or blanket to protect
the shroud from damage.
1. Remove the circuit breaker cover (G1), using a 17-mm deep
dish socket or box wrench. See figure 6.
2. Lift the battery tray shroud (G2) evenly from the Velcro®
straps, taking note of the holding slots in the frame. Reverse
these instructions to reinstall the battery tray shroud.
CAUTION: The battery tray shroud is easily
scratched. Use care when reinstalling to avoid
damage.
NOTE: If the Velcro straps need to be replaced, use needlenose pliers to spread open the
clips to remove them from the straps. Then, replace the straps with the loop ends facing up.
H. Removing and Installing the Control
Module
1. Unplug the battery harness. See figure 7.
2. Disconnect both motor harnesses.
3. Remove the jumper harness.
4. Remove the batteries from the tray.
5. Remove the two Phillips-head screws (H1) that secure
the control module (H2) to the power chair frame, using
a P2 Phillips-head screwdriver.
6. Remove the control module. Reverse these instruc-
tions to reinstall the control module.
NOTE: The controller serial number is on the
bottom of the controller module.
GP600-SM
Compass™ Service Manual
Figure 6. Battery Tray Shrouds
Figure 7. Control Module
8 RevA 02062006