Selectronic LD600-12 Operating Manual

Sine wave inverter

Advertisement

Quick Links

Selectronic Authorised Service Network

Selectronic Australia
Suite 5, 20 Fletcher Road
Victoria
Ph: +61 3 9727 6600
Fax: +61 3 9727 6601
www.selectronic.com.au
service@selectronic.com.au
Burley TV Service
278 Edmondson Ave.
Austral
NSW
2171
Australia
Ph: 02 9606-0279
Solar Inverter Services
13 Thirteenth Ave.
Sawtell
NSW
2452
Ph: 02 66581733
Suite 5, 20 Fletcher Road Mooroolbark Victoria 3138 Australia
Phone +61 3 9727 6600 Fax +61 3 9727 6601
Web www.selectronic.com.au Email sales@selectronic.com.au
CS0135 Rev 04 Part No. 003620
Mooroolbark
3138
Australia
Rainbow Power Company
1 Alternative Way
Nimbin
NSW 2480
Australia
Ph: 02 6689 1430
Fax: 02 6689 1109
Reid Technology
Unit D, 15-17 Saturn Place
North Harbour
Auckland 1330
New Zealand
Ph: 9 489-8100
Fax: 9 489-8585
psands@reidtechnology.co.nz
LD600-12 Operating Manual
Serial No _____________________________
Note - Your warranty can only be valid once your warranty card is completed and returned to Selectronic Australia
.
Purchase Date ______________

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the LD600-12 and is the answer not in the manual?

Questions and answers

Summary of Contents for Selectronic LD600-12

  • Page 1: Selectronic Authorised Service Network

    Purchase Date ______________ Phone +61 3 9727 6600 Fax +61 3 9727 6601 Web www.selectronic.com.au Email sales@selectronic.com.au Note - Your warranty can only be valid once your warranty card is completed and returned to Selectronic Australia CS0135 Rev 04 Part No. 003620...
  • Page 2: Table Of Contents

    LD600-12 Volt Owners Manual Miscellaneous Specifications Reverse Polarity Protection Full Electronic Protection Contents Page No. Output Voltage Accuracy 0-350 watts ± 4% @ 12 volt input Introduction Output Frequency 50Hz ± 0.01% Warranty Card Installation Peak Efficiency Batteries and Connections Total Harmonic Distortion <4%...
  • Page 3: Introduction

    Inverter Type Microprocessor control circuit with PWM full bridge power stage. True sine wave AC output SINE WAVE inverter. Many hours of Research and Development have gone into the LD600-12 to ensure this inverter provides you with many Current draw from Battery years of reliable service...
  • Page 4 Large amounts of DC current can be drawn by your LD600-12, Product Warranty and Conditions care must be taken. These warranty conditions apply to the LD range of Inverters for sales within Australia and New Zealand. Fixed Installation All fixed installation battery connections must be securely bolted, This product is warranted by the manufacturer for a period of 24 months from date of purchase to the original purchaser only.
  • Page 5 (see your auto electrician). The LD600-12 has sufficient battery cable length to allow it to sit underneath the vehicle whilst in use. If the ground is wet, place the LD600-12 on a waterproof liner.
  • Page 6: Batteries And Connections

    Batteries and Connections Radio Frequency Interference Batteries are the key to maximum performance from your LD600-12, if a Radio Frequency Interference (RFI) can be a problem for owners of inverters. battery is too small or not fully charged it may result in de-rated RFI in a domestic situation may produce noise or interference on a radio or performance from your LD600-12.
  • Page 7 The Ah rating of a battery will also be reduced if the discharge rate is significantly greater than the rated discharge current. See your battery specifications for full details. LD600-12 Manual Selectronic Australia LD600-12 Manual Selectronic Australia...
  • Page 8: Getting Started Quickly

    Also verify that airflow around the inverter has not become 4. Make sure the LD600-12 ON/OFF switch (12) is in the off position. restricted. 5. Connect battery positive wire (red) (10) to battery positive or battery fuse.
  • Page 9: Operation

    Low Volts Adjust LED (5) (green) FLASHING Five LEDs are provided on the front panel to indicate a number of To avoid total discharging of your battery the LD600-12 shuts down at a pre- parameters, and allow adjustment of some of these parameters.
  • Page 10 ON instead of in SLEEP mode. ON. The LD600-12 will remain in this condition for 1 minute after the AC load has been decreased to a safe level. LED (2) will flash if the inverter The wiring of a house or a portable stereo system in standby are good shuts down due to “time to shutdown”.

Table of Contents