Premium Leisure LE852 Owner's Manual page 25

Turn off the hose and check again for any small leaks.
Operational Checks
Caution: Do not turn on any pump until your hot tub is properly filled with
water. Running any pump without water in your hot tub can cause
IMMEDIATE damage, which is not covered under warranty!
By now you have rechecked your tub's mechanical connections and filled it with
water to about 1" above all jets by adding cold tap water through the pre-filter (if
equipped). Turn on power to the hot tub at the main breaker panel and test the
operation of the electrical system. If you encounter a problem, please reference
the troubleshooting guide on page 38.
1. Turn on the breaker and test the operation of the Ground-Fault Circuit
Interrupter (or RCD) breaker by pushing the small button. This should
automatically trip the hot tub's circuit breaker.
DANGER: If this breaker does not trip, immediately call your electrician.
Do not use your hot tub!
Only if pushing this button successfully trips this circuit breaker should you
reset this breaker and proceed to the next step.
2. Go to the topside control panel. The hot tub first goes into a 6-minute
Priming mode, indicated by "Pr" message. Water heating is disabled during
priming. To exit Priming mode and begin normal hot tub operation, press
"WARM" (or the up arrow) or "COOL" (or the down arrow).
3. Press the "JETS" button. You should hear pump 1 turn on, see water
circulating, and see the Jets light illuminate on the panel.
4. Press the JETS button again. You should hear the pump turn on a higher
speed.
Caution: If water is not flowing from the jets after 2 minutes, turn the
power off at the main panel and bleed air from the system (see
page 30). Turn the power on again. Sometimes momentarily
turning the pump off/on will help to prime. Do this only 4 times.
5. If the water is running smoothly through the lines, open the air control valve
to the jets and you should see an increase in jet pressure. Check and adjust
the water and airflow of every jet if necessary.
Each jet in your hot tub can be adjusted for massage intensity and
directional flow. Turn the outer jet dial counterclockwise to increase the
water volume and clockwise to turn it off. Pivot the angle of a jet to achieve
an optimal massage.
An air mixture intensifies the level of your massage. Turn the air control
valve counterclockwise to increase the air mixture and clockwise to turn it
off.
To minimize heat loss, close the air control valve when the hot tub is not in
use.
Page 23
For HELP, call 727.573.9611