Startup - Premium Leisure LE852 Owner's Manual

Important – Read these step-by-step startup procedures before starting your hot
tub. Failure to follow any of these steps listed may result in damage to the
equipment and may void your warranty.
Note: If you are unsure of any of the above startup procedures, please call our
customer care center at 727.573.9611. For best results, read each step in
its entirety before proceeding.
Caution: Running the hot tub pump dry (without water running through it) can
cause IMMEDIATE damage and will void the warranty! Be sure that
the hot tub is installed properly in accordance with the instructions in
this manual.
Refer to the following picture for an explanation of your hot tub's controls,
components, and technical terms. Note that not all models have all features and
components.
Before Adding Water
Before adding water, go through these simple steps now to prevent common
issues when setting up your
have all been rechecked.
1. Turn off all power to the
2. Open the side panels to access the internal components.
3. Check that all slide valves are opened (T-
handles pulled out) to the heater and all
pumps.
4. Check that there are no obvious signs of
loose wires or broken pipes.
5. Check that the two heater unions are
hand tight.
Caution: Do not use a wrench. Over-
tightening may cause damage
to unions and gaskets, which
will not be covered under
warranty.
6. Check that the unions on all pumps are tight.
7. Clean out any foreign debris from within the service access area or inside of
S t a r t u p
hot tub for the first time. Verify that the following
hot tub at the main breaker panel.
Figure 15 - Valve Open/Closed
Figure 16 - Unions Tight
Page 21
For HELP, call 727.573.9611