Kohler K91 Service Manual page 32

available . Always refer to the Parts Manual for the
engine being serviced to ensure that the correct
carburetor repair kits and replacement parts are
ordered .
Choke Detent Bal l - Sp r i n g -- ,
C hoke Shaft Bush i n g
Choke Plate ( Reused)
# 3 - 48x7/32"
Brass Screws
I �
"
#2-56x7/32" o r
#3-48x7/32"
Brass Screw
�
WARNI NG:
Prevent Eye InJuryl
Suitable eye protection (safety glasses, goggles, or
face hood ) should be worn for any procedure involv­
ing the use of compressed air, punches, hammers,
chisels, drill s , or grinding tools.
Disassemble Carburetor
Refer to " Disasse mbly " at the beginning of this
section .
6 . 6
# 2-56x7/32" o r # 3-48x7l32"
B'ass Sc'ew
Throttle Shaft -4 Styles
For Models K24 1 - K341 &
KT1 7- K T 1 9, 1 " Ca,b.
\
Chok e Shaft Bush i n g
, @
\
Choke Lever
(Reused)
Figure Throttle And Choke Shaft Replacement Kits.
6-8.
Throttle And Choke Shaft
Replacement
To Replace Throttle And Choke Shafts
Two kits are available that allow replacement of
the carburetor throttle and choke shafts of Kohler
carburetors. Refer to Figure 6-8.
Throttle Shaft/Lever Asse m b ly-
2 Styles For Models
K91 - K 1 8 1 , 1 /2" Carbo
,
# 3 - 48x7/ 32 "
Brass Screws
-
'�\J
'
Throttle P l ate ( Reused )
Bowl Gas ket
Remove Choke Plate and Choke Shaft;
Transfer Choke Lever
1 .
To ensure correct reassembly. mark choke
plate and carburetor body with a marking pen .
Also take note of choke plate position i n bore
and choke lever position .
2 . Carefully and slowly
ing choke plate to choke shaft . Remove and
save the choke plate as it will be reused .
Throt tle
Lever
( Reused )
I
Th<attle Shaf1 B u s h i n g
\
Throttle Shaft Bu s h i n g
I n sta l lation Tool
remove the screws secur­