GE Max Profile Use And Care Manual page 5

HOW TO OPERATE YOUR DISHWASHER
SPEED CYCLE Heavy 7.7 gal., 35.2 litre, 36 min.
Medium 6.0 gal., 27.3 litre, 36 min.
Light 4.7 gal., 21.6 litre, 33 min
This cycle is for everyday dishes and glassware.
CHINA CRYSTAL Heavy 8.3 gal., 37.8 litre, 49 min.
Medium 6.0 gal., 27.3 litre, 36 min.
Light 6.0 gal., 27.3 litre, 36 min
This cycle is for lightly soiled china and crystal..
GLASSES Heavy 8.3 gal., 37.8 litre, 45 min.
Medium 6.0 gal., 27.3 litre, 33 min.
Light 6.0 gal., 27.3 litre, 32 min
This cycle is specifically designed for glasses..
RINSE ONLY Heavy 2.4 gal., 10.9 litre, 7 min.
Light 1.2 gal., 5.3 litre, 3 min.
For rinsing partial loads that will be washed later. Do not use detergent with this cycle.
NOTE: This dishwasher is equipped with an ExtraClean™ Sensor with automatic temperature control;
therefore cycle length and time may vary depending on soil and temperature conditions.
NOTE: Only the Anti-Bacteria cycle has been designed to meet the requirements of Section 6, NSF 184
for soil removal and sanitization efficacy.
Enhancements
4
B
The light above the selected pad will be ON to indicate which ENHANCEMENT has been selected.
PRE WASH For use with heavily soiled and/or dried-on, baked-on soils. This option MUST be
selected PRIOR to starting the cycle. This option adds 16 minutes to the cycle time.
NOTE: Cannot be selected with RINSE ONLY cycle.
HEATED DRY Shuts off the drying heat option. Dishes air dry naturally and energy is saved. For faster
Light OFF air dry, you can prop the door open after the CLEAN light illuminates.
HEATED DRY Turns the heater on for fast drying. This will extend the time to your wash cycle by
Light ON 8 minutes for SPEED CYCLE and 30 minutes for all other cycles. NOTE: Cannot be
selected with RINSE ONLY cycle..
LOCK You can lock the controls to prevent any selections from being made. Or you can lock the
controls after you have started a cycle.
Children cannot accidentally start dishwasher by touching pads with this option selected.
To unlock the dishwasher controls, press and hold the HEATED DRY pad for 3 seconds.
To lock the dishwasher, press and hold the HEATED DRY pad for 3 seconds. The light
above the LOCK pad will turn off.
ADDED HEAT When selected, the cycle will run longer with heating elements on to improve both wash
and dry performance. NOTE: Cannot be selected with RINSE ONLY cycle.
DELAY HOURS You can delay the start of a wash cycle for up to 9 hours (on some models). Press the
DELAY HOURS pad to choose the number of hours you want to delay the start of the
cycle, then press START/RESET. The machine will count down and start automatically
at the correct time. Pressing START/RESET a second time will cancel the DELAY
START selection. NOTE: If you forget to fully close the door a reminder signal will
beep until you do so.
RESET To change a cycle after washing starts, touch the START/RESET pad to cancel the cycle.
The START/RESET light will flash while the water is pumped out if needed. This takes
approximately 90 seconds. When the light stops flashing, the dishwasher can be
reprogrammed and restarted.
5