Advertisement
SPECIFICATION
INSTALLATION
E
D
C
G
A
B
F
I
1
Use the supplied hexagon wrench to remove the four
fixing screws (B) of dome cover (A).
2
Make screw holes and a cable hole in the supplied
cushioning sheet (D) that attaches to the back of the
camera unit (C) .
3
Attach the cushioning sheet (single-sided tape) to the
back of the camera unit.
4
Align the camera unit with the surface of the ceiling,
make marks on the ceiling in the places where the
screw holes are to be drilled, and then drill the four holes.
5
Cut a hole (diameter:73mm) in the ceiling for routing
the cables.
6
Pass the power cable (E) and video cable (F) from the
camera unit through the cable hole in the ceiling.
7
Align the four screw holes in the camera unit (C) with
the screw holes in the ceiling, and then secure the
camera in place by tightening the four or more screws
(G) throught the washers.
8
Carry out the settings and adjustments for the camera.
9
If the dome liner (H) is secured in place, loosen the
screw (I).
Adjust the dome liner (H) so that the dome camera's
lens is visible from the camera window, and then
H
use a philips screwdriver to fix the dome cover.
10 Secure the dome cover (A) by tightening the screws (B).
Advertisement
