Icom IC-2720H Operating Manual page 4

Operating in Memory Mode
● Press L/R M/CALL●MW
[
● To change the Memory channel, rotate
● To start a scan, press and hold
● To stop a scan, press
Alternatively: See "Using the HM-133 Microphone" section for instructions
on using the microphone ▲/▼ and/or keypad buttons to perform these
operations.
Memory Bank Selection
The IC-2720H has 10 Memory Banks (A to J), each of which can contain up
to 200 Memory channels. To select a Memory channel within a Bank:
M/CALL●MW
1. Press L/R [
MAIN●BAND
2. Press and hold [
selection. (The Bank initial blinks on the LCD display.)
DIAL
3. Rotate [ ] to display the desired Memory Bank.
MAIN●BAND
4. Press [
blinking.)
5. Rotate the Dial to select a Memory channel within the bank.
To return to regular Memory mode, press and hold
then momentarily press
Using the Monitor Function
This function is used to listen to weak signals
without disturbing the squelch setting.
● To activate, press and hold L/R
sec. to open the squelch. (The "Busy" icon blinks
on the LCD display`.)
● To cancel, press and hold
Selecting the Call Channel
Call channel is a pre-programmed Memory channel
accessed by pressing the Call channel button.
M/CALL●MW
1. Press L/R [
activate Call Channel mode.
DIAL
2. Rotate [ ] to select the desired call channel.
(In Memory mode, the "C1" or "C2" icon
appears. In VFO mode, the "c" icon appears.)
3. To cancel Call Channel mode, press
M/CALL●MW
[ ] one or more times.
Icom IC–2720H Mini–Operating Guide by W5JCK, September 2007
] one or more times to activate Memory mode.
DIAL
[
V/MHz●SCAN
[
V/MHz●SCAN
[ ].
] one or more times to activate Memory mode.
] for 1 sec. to activate the Memory Bank
] to select the Memory Bank. (The Bank initial stops
MAIN●BAND
[ ] again.
DUP●MONI
[ ]
DUP●MONI
[ ] for 1 sec.
] one or more times to
].
] for 1 second.
MAIN●BAND
[ ] for 1 sec.
for 1
Alternatively: Press the HM-133 microphone
BANK●MONI●1
button [
Monitor function.
Alternatively: Press and hold the HM-133
microphone button
activate the Call Channel mode, then press ▲ or
▼ to select the desired call channel in the main
Band.To cancel, press
Memory mode.
] to activate or cancel the
MR●CALL
[ ] for 1 sec. to
MR●CALL
[ ] to return to
Page 4 of 6