Table of Contents
Advertisement
EDS7001F
If the unit was operating prior to servicing allow at least 10 minutes for light bulbs and
heating element to cool off to avoid accidental burning of skin.
Disconnect power before attempting any maintenance or cleaning to reduce the risk of
electric shock or damage to persons.
TO REPLACE THE HEATER ASSEMBLY
NOTE
Do to the partial disassembly of the stove care must be taken not to scratch any
surfaces or damage any components during the repair.
1. Unscrew the two black knobs on the front of the unit by turning counterclockwise.
2. Grasp onto the front door, gently lift up and pull the door off of the unit.
3. Remove logset screw and remove logset.
4. Remove the upper light bracket mounting screws from the top and remove the
light bracket assembly from the unit.
5. Locate the four cam locks on the side panels inside the upper corners of the
stove and turn with a large slot screwdriver so the triangle on the cam lock is
pointing up towards the top of the stove.
6. Grasp the top at both sides and gently pull to release the top.
7. Locate and remove the mirror by pulling it out of the slots being careful not to
bump or drop it.
8. Remove (10) screws from back panel assembly.
9. Locate the main on/off switch mounted on the rear panel and disconnect the
wiring connections noting their original locations.
10. Remove the (2) screws from the front mirror panel.
11. Slide the rounded side panels straight up and remove both panels.
12. Remove the front mirror panel through the front of unit.
13. Remove (2) rear nylon clips from bottom panel.
14. Loosen strain relief with flat headed screwdriver located on bottom of unit.
15. Locate and remove the two screws in front of the light bulbs from the main
component panel.
14
Advertisement
Table of Contents
