Table of Contents
Advertisement
EDS7001F
If the unit was operating prior to servicing allow at least 10 minutes for light bulbs and
heating element to cool off to avoid accidental burning of skin.
Disconnect power before attempting any maintenance or cleaning to reduce the risk of
electric shock or damage to persons.
TO REPLACE POWER CORD
1. Unscrew the two black knobs on the front of the unit by turning counterclockwise.
2. Grasp onto the front door, gently lift up and pull the door off of the unit.
3. Remove the upper light bracket mounting screws from the top and remove the light
bracket assembly from the unit.
4. Locate the four cam locks on the side panels inside the upper corners of the
stove and turn with a large slot screwdriver so the triangle on the cam lock is
pointing up towards the top of the stove.
5. Grasp the top at both sides and gently pull to release the top.
6. Locate the main on/off switch mounted on the rear panel and disconnect the
wiring connections noting their original locations.
7. Remove (10) screws from back panel assembly.
8. Slide the rear panel up approximately four inches.
9. Locate and remove the wiring connections for the power cord.
10. With needle nose pliers grasp the power cord strain relief grommet from inside
the rear cover and push while twisting to remove.
11. Pull the old power cord out through the rear cover.
12. Install the power cord retaining grommet on the power cord and insert into the
hole in the rear cover.
13. Reconnect all of the wiring clips and connections.
NOTE
The wires that require to be wire connected together are secured in a strain
relief. The strain relief can be loosened with a flat headed screwdriver.
14. Reassemble in the reverse order as above.
13
Advertisement
Table of Contents
