Silhouette DIM3225BLSST Owner's Use And Care Manual page 9

Ice Maker Performance Mode Instructions (cont)
Performance
Mode
Unnecessary water
Drain pump mode.
will be forced out
the drain by the
pump.
NOTE:
1. If you take out the bottom board of the ice box, it will make the volume of the ice box larger and
therefor will keep more ice.
2. If your operating using the "Manual drainage system mode", ice will restrict drain water from flowing out.
CONTROLS OF THE ICE MAKER
The Ice Maker should be placed where the ambient temperature is between 5-35°C (41-95°F). If the ambient
temperature is above or below this range, the performance of the unit may be affected.
OPERATING INSTRUCTIONS
Instructions Suitable situation
The height of drain
hole in the room is
between 10cm~150cm
Operation instruction
Ref: Fig.A & Fig.B & Fig.C (page 5)
Drain Nut and Switch
drain nut (front) (3) + drain seal (front) (4)
drain nut (back) (7) + drain seal (back) (6)
drain cap (11)
drain cap (12)
drain pump switch (8)
1. Please insure the drain nut and switch are in the
above condition;
2. Use a drain tube with a length of (4 feet). Connect one
side to the drain pump outlet (10) and the other to the
drain hole. Please insure the connection is tight to
avoid water leakage.
7
Condition
lock
open
open
lock
on