Silhouette DIM3225BLSST Owner's Use And Care Manual page 8

Ice Maker Performance Mode Instructions (cont)
Performance
Mode
Manually drain the
Manual drainage
system mode water from the ice
box.
Direct drainage Unnecessary water
will be drained off
mode (continuous)
by the outlet water
pipe on the back of
the unit
OPERATING INSTRUCTIONS
Instructions Suitable situation
There is no drain hole
in the room
The height of drain hole
in the room is less than
<10cm> high.
Operation instruction
Ref: Fig.A & Fig.B & Fig.C (page 5)
Drain Nut and Switch
drain nut (front) (3) + drain seal (front) (4)
drain nut (back) (7) + drain seal (back) (6)
drain cap (11)
drain cap (12)
drain pump switch (8)
1. Please insure the drain nut and switch are in the
above condition to avoid water leakage.
2. Periodically check the Ice box (1), water level sight(5).
If the water level exceeds the ruler water level,please
drain off the unnecessary water.
3. When draining off the water, you can remove the Ice
box(1), drain nut (front) (3) and drain seal (front) (4)
use the holder to take out the unnecessary water, then
tighten the above drain seal and nut.
Ref: Fig.A & Fig.B & Fig.C (page 5)
Drain Nut and Switch
drain nut (front) (3) + drain seal (front) (4)
drain nut (back) (7) + drain seal (back) (6)
drain cap (11)
drain cap (12)
drain pump switch (8)
10cm 1. Please insure the drain nut and switch are in the
above condition;
2. Use a drain tube with a length of (4 feet). Connect one
side to the direct water outlet pipe connection (13) and
the other to the drain hole. Please insure the
connection is tight to avoid water leakage.
6
Condition
lock
lock
lock
lock
OFF
Condition
lock
open
lock
open
OFF