Silhouette DIM3225BLSST Owner's Use And Care Manual page 6

Connecting Ice Maker To Water Supply (cont)
Drain-pipe Connection (Drain hose not provided)
• If you choose direct drainage or force drainage mode you
need to purchase the external drain pipe available at your
local hardware store. The connection instructions are
below: Connect one side of the external drain pipe linker to
the outlet pipe of ice maker, the other side is put into the
drain hole. (see Fig B.)
A - Is a pump assisted drain
B - Is a gravity fed continuous drain
NOTE: When using pump assisted drain "A" the
switch (on back) must be turned to "ON"
position.
DOOR REVERSAL
INSTRUCTIONS
This appliance has the capability of the door opening from either the left or the right side. The unit is delivered to you
with the door opening from the left side. Should you desire to reverse the opening direction, please follow these
instructions.
Fig. A
A
3
1 2
Fig. C
C
1. Remove 2 screws (1), then pull door (4) in arrowhead direction.
2. Remove 3 screws of right upper Hinge (5), then remove right upper hinge(See Fig.C)
3. Use the screws which you removed from the right side hinges to fix the left upper and bottom hinges (8)
(See Fig.D &Fig.E)
4. Rotate the door 180°, then assemble the door on the opposite side in the same way it was removed.
INSTALLATION INSTRUCTIONS
4
Fig. D
D
5
6
7
Fig B.
Washer
Tube Connection
Tubing
Fig. B
B
5
4
Fig. E
E
8
4
Switch
A
B
1. Screws
2. Bottom hinge (Right)
3. Door axis
4. Door
5. Top hinge (Right)
6. Lock screws
7. Top hinge (Left)
8. Bottom hinge (Left)