Advertisement
Control Panel
Front Panel
Boiler Safety
Overheat Neon
Osprey 2
Boiler Safety
Fig. 2
Overheat Reset
4
Flame Failure
Burner On
Neon
Neon
RESET
RESET
ON / OFF
On/Off
Flame Failure
Button
Reset Button
2.0 Operating the Boiler
2.1
1. Your Potterton Osprey 2 CFL is a gas fired,
open flue, floor standing boiler. The boiler can be
used to supply hot water for central heating, and
domestic hot water when used in conjunction with
an indirect cylinder.
2. The boiler is designed for use on fully pumped
open vented or sealed systems. It can be used on
Natural Gas (G20) only.
3. Instructions for use can also be found behind
the boiler front panel (Fig. 1).
2.2
1. Ensure that the gas and electricity supplies are
turned on and that all timers, thermostats etc. are
calling for heat.
Fig. 1
2. The Power On neon should be illuminated.
3. Push the On/Off button in. The button will
illuminate and the ignition sequence will start.
Power On
4. The pilot flame will light followed by the main
Neon
burner. This is indicated by the Burner On neon
illuminating.
5. The optimum setting of the boiler temperature
control depends upon type of system, external
controls and your requirements. Your Installer will
be able to advise you on this matter.
2.3
Temperature
1. If at any time the burner is extinguished while
Control
there is still a demand for the boiler to operate the
Flame Failure neon will illuminate. The Burner On
neon will extinguish.
2. Pressing the Flame Failure reset button will
restart the ignition sequence.
3. If the Flame Failure neon illuminates repeatedly
a fault is indicated. Your Service Engineer should
be contacted as soon as possible.
2.4
1. The boiler is fitted with an additional safety
device, which shuts down the boiler in the event of
the system or the boiler overheating.
2. If the device operates, the Boiler Safety
Overheat neon will illuminate and the boiler will
shut down.
3. Unscrew the cap off the Boiler Safety Overheat
Reset. Press the reset button to restart the ignition
sequence.
4. If the Boiler Safety Overheat neon illuminates
repeatedly a fault is indicated. Your Service
Engineer should be contacted as soon as
possible.
Introduction
Operating the Boiler
Flame Failure
Boiler Safety Overheat Thermostat
Advertisement
