Oki PACEMARK 4410 Service Manual page 10

(5) Maximum Number of Dot Columns per Line
a) Graphics
Single Density
816
b) Text
Print Mode
ML, EPSON, IBM UTILITY
ML, EPSON, IBM NLQ
ML, EPSON, IBM HSD
(6) Maximun Number of Character per Line
Character Pitch (CPI)
ML EPSON IBM
(7) Printhead
Print method:
Number of dot wires:
Dot wire diameter:
(8) Line feed Speed
6 LPI spacing, one LF = 60 ms
8 LPI spacing, one LF = 52 ms
Continuous paper feed rate is 15 inches per second. (at head gap 1, 2)
(9) Line Feed Pitches
6 LPI 0.167 inch (4.23mm)
8 LPI 0.125 inch (3.175mm)
A variable line feed pitch of n/216 inch (integer n: 0 ≤ n ≤ 255) can also be specified. Also,
7/72 inch and n/72 inch can be specified.
PROPRINTER
EPSON
(10) Power Requirements
a) Input power
Single-phase AC
Voltage : 120VAC +5.5%, -15%
230 VAC ±15%
Frequency : 50/60Hz ±2%
b) Power consumption
Local Test : Max. 295 W (Rolling ASCII, Utility)
Idle : Max. 15W (Energy Star compliant)
c) AC power cable
Length : Approximately 5.9 It (1.8 m)
Cable conforms to the UL, CSA, and European Standards.
Note : AC power cable is not supplied.
Double Density
1,632
Character Pitch (CP)
10 CPI 12 CPI
1,632 1,958
3,264 3,917
1,224 1,468
5 6 7.5 8.5
68 81 102 116
Impact dot matrix
9 wires x 2 rows
0.36mm(0.014inch)
n : 1 ≤ n ≤ 255
n : 1 ≤ n ≤ 255 (Cannot specify MSB : 1≤ n ≤ 127)
Quadruple Density
3,264
15 CPI 17.1 CPI 20 CPI
2,448 2,798 3,264
4,896 5,596 6,528
1,836 2,098 2,448
10 12 15 17.1
136 163 204 233
9
20
272