Performax 241-0988 Operating Manual page 7

SERvICE
Tool service must be performed only by qualified repair personnel.
Service or maintenance performed by unqualified personnel could result in
a risk of injury.
When servicing a tool, use only identical replacement parts. Follow
instructions in the Maintenance section of this manual. Use of unauthorized
parts or failure to follow Maintenance instructions may create a risk of electric
shock or injury.
SPECIFIC SAFETY RULES FOR RECIPROCATING SAW
Hold the tool by insulated gripping surfaces when performing an
operation where the cutting tool may contact hidden wiring or its own
cord. Contact with a "live" wire will make exposed metal parts of the tool
"live" and shock the operator.
Secure material before cutting. Never hold the material you are cutting in
your hand or across legs. Small pieces or thin material may flex or vibrate with
the blade, causing loss of control.
Obtain advice from a qualified person if the operator is not thoroughly
familiar with the operation of a reciprocating saw.
The reciprocating saw is double insulated. When servicing, use only
identical replacement parts.
Avoid cutting nails when using the wood blade. Inspect the workpiece
carefully and remove all nails and staples before cutting.
Verify that the blade always extends beyond the shoe and the workpiece
throughout the stroke. Blades may shatter if they strike the workpiece or the
shoe.
Do not cut oversized workpieces.
Check for proper clearance beyond the workpiece before cutting, so that the
blade will not strike the floor, the workbench, etc.
Verify that the blade is not in contact with the workpiece before the switch
is turned on.
Keep the saw blades clean and sharp.
Use only correct blades. Always use blades that are recommended for the
material and type of workpiece being cut.
Do not leave the tool running. This tool is only intended to be operated when
hand held.
7