Section 7.4 Anti-Tailgating - Assa Abloy Securitron DK-26 Installation And Operating Instructions Manual

7.4 ANTI-TAILGATING
Particularly when using the longer time ranges, the end user may be concerned that after an
authorized person has used the door, a second unauthorized person can also use it before the
lock has reset. By the addition of a door switch which opens when the door opens, the DK-
26 can be made to re-engage the lock as soon as the door has re-closed regardless of the status
of the timer. To implement this feature, a special command has to be sent to the CPU board
which will alter the function of either the HCD or UCD input terminal. When you enable this anti-
tailgating feature, you must give up the capability of disabling either the Hard code or all the
User codes.
Put the unit into program mode and enter 8-0 to
assign this function to the HCD terminal or 8-
1 to assign it to the UCD terminal.
see the two flash confirmation.
program mode.
Finally connect a door switch as shown in the
drawing to the right and you will see that the door
will always relock immediately when it recloses regardless of how much time is left on the timer.
The feature will operate when the door has been released from the keypad or from the REX
input (see Section 3.6). Note that to disable the anti-tailgating feature and return full function
to the HCD and UCD terminals, put the unit into program mode and enter 8-4. Note that the
DK-26 supports a more powerful anti-tailgating feature which incorporates an alarm signal
through the use of the programmable relay. Read Section 6.4 for details.
7.5 WIRING WITH SECURITRON'S TOUCH SENSE BAR AND MAGNALOCK
The DK-26 is often used with Securitron's Touch Sense Bar and magnetic lock. The following
drawing shows wiring for this particular configuration.
Since touching the bar opens the door in a single motion, you do not want to activate the DK-
26's timer which would only serve to keep the lock released for a longer time, thereby reducing
security. Another potentially confusing element is that the Touch Sense Bar is also a powered
device which operates most reliably when it is constantly powered. The drawing shows a wiring
method that is applicable for either an AC or DC power supply (naturally, the supply voltage
must be matched to the lock voltage).
desired if you are using the second pole of the DK-26's lock control relay to shunt an alarm
system (see Section 7.3).
control relay in double break fashion so that the alarm system is shunted both for entry and exit.
Simply follow Figure 9 except also connect the blue and orange wires from the Touch Sensor to
terminals SRC and REX on the CPU board (as well as connecting the second pole of the lock
control relay to the alarm point as shown in Section 7.3).
FIG. 9: WIRING OF DK-26, TOUCH SENSE BAR AND MAGNALOCK
NOTE: SEE FIG. 2 FOR 12 WIRE
KEYPAD CABLE CONNECTIONS
IF AC POWER IS
BEING USED,
CONNECT 12
OR 24 VAC TO
AC IN TERMINALS
IF DC POWER IS
BEING USED,
CONNECT 12
+
OR 24 VDC TO
DC IN/OUT
TERMINALS. BE
SURE TO OBSERVE
POLARITY
You will
Then, exit
Note that a variation of this wiring scheme could be
You would then want the Touch Bar to operate the DK-26's lock
+
CPU BOARD
NC1 C1
POWER SUPPLY VOLTAGE MUST MATCH VOLTAGE OF MAGNALOCK
Page 16
CONNECT A DOOR
SRC UCD HCD
SWITCH WHICH
OPENS WHEN THE
DOOR OPENS TO
UCD OR HCD
DEPENDING ON WHICH
COMMAND YOU CHOOSE
DOOR SWITCH
Note that the REX input is not used.
WHITE
RED
TOUCH
SENSOR
RED
MAGNALOCK
BLACK
PN# 500-16900
Rev. C, 1/09