Troubleshooting - Neue IDSH601W User Manual

Cleaning the filters
1
3
To remove filters (B) and
(C), turn the handle coun-
terclockwise and remove.
Pull apart filter (B) and
(C). Wash the filters with
water.

Troubleshooting

The appliance does not start or it stops during opera-
tion.
Before you contact the Service, refer to the information
that follows for a solution to the problem.
Alarm code
• The indicator of the set programme flashes continu-
ously.
• The end indicator flashes 1 time intermittently.
10
C
B
A
2
A
4
Remove filter (A). Wash
the filter with water.
D
A
5
Put filter (A) to its initial
position. Make sure that it
assembles correctly un-
der the two guides (D).
An incorrect position of the filters can cause bad
washing results and damage to the appliance.
Cleaning the spray arms
Do not remove the spray arms.
If the holes in the spray arms are clogged, remove re-
maining parts of soil with a thin pointed object.
External cleaning
Clean the appliance with a moist soft cloth.
Only use neutral detergents. Do not use abrasive prod-
ucts, abrasive cleaning pads or solvents.
Internal cleaning
If you regularly use short duration programmes, these
can leave deposits of grease and limescale inside the
appliance.
To prevent this, we recommend to run long duration pro-
grammes at least 2 times per month.
With some problems, different indicators flash con-
tinuously or intermittently at the same time to show
an alarm code.
Problem
The appliance does not fill with water.
6
Assemble filters (B) and
(C). Put them into posi-
tion in filter (A). Turn the
handle clockwise until it
locks.