Operation; Initial Setting - AB IPBox 9900HD User Manual

Operation:

AB IPBox 9900HD PVR with AB Enigma2 HD firmware
AB Enigma2 HD firmware was developed to enable simple and comfortable control of all
functions of your receiver.
Powering Up the receiver
a) Before connecting the power cord, connect to the receiver your other components and
antenna (see examples in previous chapter). Finally connect the power cord to a suitable wall
outlet.
b) Turn on your TV and select HDMI input in its menu (or different corresponding input
according to your real physical connection).
c) Press the POWER switch on the rear panel to turn on the power. Time indicator is
displayed.
Press the STANDBY button on the front panel or RC.
Starting the receiver and booting the system may last about 2 minutes; initial logo is displayed
during this process. Wait till the end of starting.

Initial Setting

If you do not see any picture on your TV, wait and check the message on the display. The
receiver automatically switches over all outputs. Press the OK button when you see
corresponding output on the display.
Outputs are continuously switched over in following order: Component – SCART – HDMI.
Select SCART (SD-PAL 50Hz) if you use SCART – SCART connection.
Select 1080i if you use Component connection.
Select 1080i if you use HDMI connection.
The refresh frequency menu appears after selection of HDMI. Set 50 or 60Hz according to
your TV. TV sets commonly used in Europe use 50 Hz – confirm the selection by pressing the
OK button.
If you accidentally set incorrect resolution and there is none or incorrect picture on your
screen you can repeat the setting up:
- Turn off the power of your IPBox by pressing the switch on the rear panel.
- Turn on the receiver and watch the display.
- Press and hold for a short while the MENU button on the front panel when IPBOX
9900 message appears on the display.
- Available resolutions are displayed (SD-PAL, 720p, 1080i-50Hz, 1080i-60Hz...)
- Use Right – Left arrow buttons to select corresponding resolution and press OK. New
booting with new settings starts.
- Wait until Installation wizard (guide) appears.
20