Table of Contents
Advertisement
User Manual of AAR-W450K and AAR-W850K Series DVR
8.1 Configuring General Settings
Purpose:
Network settings must be properly configured before you operate device over network.
Steps:
1. Enter the Network Settings interface.
Menu > Configuration > Network
2. Select the General tab.
3. In the General Settings interface:
You can configure the following settings: NIC Type, IPv4 Address, IPv4 Gateway, MTU and DNS
Server.
If the DHCP server is available, you can click the checkbox of DHCP to automatically obtain an IP
address and other network settings from that server.
Note:
The valid value range of MTU is 1280 ~ 1500.
4. After having configured the general settings, click the Apply button to save the settings.
8.2 Configuring Advanced Settings
8.2.1 Configuring PPPoE Settings
Purpose:
Your device also allows access by Point-to-Point Protocol over Ethernet (PPPoE).
Steps:
1.
Enter the Network Settings interface.
Menu > Configuration > Network
2.
Select the PPPoE tab to enter the PPPoE Settings interface.
Figure 8.1 General Network Settings Interface
91
Advertisement
Table of Contents
