Configuring Encoding Parameters - Aasset AAR-W450K User Manual

User Manual of AAR-W450K and AAR-W850K Series DVR

4.1 Configuring Encoding Parameters

Purpose:
By configuring the encoding parameters you can define the transmission stream type, the resolution and so on.
Before you start:
1. Make sure that the HDD has already been installed. If not, please install a HDD and initialize it.
(Menu>HDD>General)
2. Check the storage mode of the HDD
1) Click Advanced to check the storage mode of the HDD.
2) For Quota storage mode, please set the maximum record capacity. For detailed information, see
Chapter 9.2 Configuring Quota Mode.
Steps:
1. Enter the Record settings interface to configure the encoding parameters:
Menu>Record>Encoding
Figure 4.1 HDD- General
Figure 4.2 HDD- Advanced
32