Table of Contents
Advertisement
User Manual of AAR-W450K and AAR-W850K Series DVR
4.
Click the Apply button to save and exit the menu.
8.2.8 Configuring Server and HTTP Ports
Purpose:
You can change the server and HTTP ports in the Network Settings menu. The default server port is 8000 and
the default HTTP port is 80.
Steps:
1.
Enter the Network Settings interface.
Menu > Configuration > Network
2.
Select the More Settings tab to enter the More Settings interface.
3.
Enter new Server Port and HTTP Port.
4.
Enter the Server Port and HTTP Port in the text fields. The default Server Port is 8000 and the HTTP
Port is 80, and you can change them according to different requirements.
5.
Click the Apply button to save and exit the interface.
Note:
The Server Port should be set to the range of 2000-65535 and it is used for remote client software
access. The HTTP port is used for remote IE access.
8.2.9 Configuring Email
Purpose:
The system can be configured to send an Email notification to all designated users if an alarm event is
detected, a motion detection event is detected, etc.
Before configuring the Email settings, the device must be connected to a local area network (LAN) that
maintains an SMTP mail server. The network must also be connected to either an intranet or the Internet
depending on the location of the e-mail accounts to which you want to send notification.
Steps:
1.
Enter the Network Settings interface.
Menu > Configuration > Network
2.
Set the IPv4 Address, IPv4 Subnet Mask, IPv4 Gateway and the Preferred DNS Server in the Network
Settings menu.
Figure 8.20 Host/Others Settings Menu
99
Advertisement
Table of Contents
